Skip to main content

ohm's Law

Ohm’s  Law:
 Ohm's  law  states  that  the  current  through  a  conductor  between  two  points  is  directly proportional  to  the  potential  difference  or  voltage  across  the  two  points,  and  inversely proportional  to  the  resistance  between  them.  
The  mathematical  equation  that  describes  this relationship  is: where  I  is  the  current  through  the  resistance  in  units  of  amperes,   V is  the  potential  difference  measured  across  the  resistance  in  units  of  volts,   and  R  is  the  resistance  of  the  conductor  in  units  of  ohms.   More  specifically,  Ohm's  law  states  that  the  R  in  this  relation  is  constant, independent  of  the  current.
         
Transformer
Servo motor

Comments

Post a Comment

Hey guys if any problem has about Electrical engineering. You can message me , I will do my best for you

Popular posts from this blog

multimeter

What is a digital multimeter? A  digital multimeter  is a test tool used to measure two or more electrical values—principally voltage (volts), current (amps) and resistance (ohms). It is a standard diagnostic tool for technicians in the electrical/electronic industries. Digital multimeters long ago replaced needle-based analog meters due to their ability to measure with greater accuracy, reliability and increased impedance. Fluke introduced its first digital multimeter in 1977. To better  understand  digital  multimeters,  it’s  helpful  to  become  clear  on  the  basics  of electricity.                       After  all,  digital multimeter  always  measure  some  aspect  of  electricity. In  the  case  of electricity,  that  force  might  be  a...
1 comment
Read more

Annemometer

Annemometer is also known as wind speed meter. It is a measuring device.  It measure wind speed and it's direction. The term is derived from the Greek word  anemos , which means  wind , and is used to describe any wind speed instrument used in  meteorology . The first known description of an anemometer was given by  Leon Battista Alberti  in 1450. Connection For connection we need a wind speed sensor  & device for reading signal of sensor. First of we need a DC supply for activate sensor and device. Above picture it clear that wiring diagram. When a DC power supply connected with sensor and it blade run then in output we get signal. That signal connected in device. And device show result. Wind speed measure in m/s, kph, mph. Application Mostly wind speed meter used in industrial areas. And also it use in home.
Post a Comment
Read more

Zoomlion Qy 50v Load chart free pdf download

A Chinese construction machinery manufacturer, having taken on the mission of contributing to our motherland through industry and through the great ambition of "broadening our vision by aiming high" for more than fifty years, we have taken one firm step after another on our way towards allowing "Made in China" to challenge the world standard. With steps restlessly marching forward and with a long, winding path covered by single individual strides for over half a century, each and every footprint made, burdened under heavy loads, demonstrates nothing but the strong demeanor and ambition that a climber shows while looking down upon everything from mountain peak. We have experienced innumerable glorious moments over the past fifty years, such as: showing our strength in the centennial Three Gorges Project, being highly praised for building the Antarctic Scientific Exploration Bases, challenging the extreme construction conditions on the Qinghai-Tibet Platea...
Post a Comment
Read more